Haltech Platinum PRO Z32 300zx HT-055107


Some items may ship from the manufacturer. Contact us to verify stock before ordering.

SKU: HAL HT-055107 Category:


? Direct plug and play replacement of the OEM ECU, no re-wiring necessary.
? Uses the cars factory sensors
? Supports Sequential Injection (peak and hold) and Direct fire ignition
? Windows 2000, XP, Vista, Windows 7 compatible software
? Real time programming, instant hesitation free adjustment while engine is running
? Fully user definable 32 x 32 mapping
? Tuning via Volumetric Efficiency (VE), Injection time or Lambda Correction (MAF)
? Diagnostic trouble code storing & Check engine light control(Access through laptop only )
? Selectable onboard internal MAP sensor rated to 150kPa (up to 1.5 Bar or 22psi boost)
? Wideband ?auto tuning? using user definable target AFR table
? USB and CAN Communication Port

Factory Outputs:
? 6 x Fuel Injector outputs
? 6 x Ignition outputs
? N-VCT (Nissan Variable CAM Timing Control)
? Tacho, Boost Control, AC Clutch Relay, Idle Control
? Thermo Fan, Check Engine Light, Fuel Pump (Variable Speed)

Factory Inputs:
? MAF sensors, Throttle Position Sensor, Oxygen sensors,
? Coolant Temperature sensor, Vehicle Speed Sensor,
? Fuel Temperature sensor, Knock Detection Sensor

Expansion I/O*:
2 x Analogue Voltage inputs
? 2 x Analogue Temperature inputs
? 4 x Digital Outputs
*Optional auxiliary harness required to be purchased Haltech Part # HT040003

? Dual Bank Closed Loop O2 Control
? Knock Control
? Long Term Fuel Trim
? Over Boost
? Rev Limiter
? Closed & Open Loop Boost Control
? Gear Setup
? ACF On Base Tables
? Transient Throttle Enhance
? Decel Cut

Correction Tables: Fuel Ignition Boost:
? Cranking
? Air Temp Target Correction
? Zero Throttle Gear Correction
? Cylinder Trim
? TPS Correction
? Generic Correction 1
? Generic Correction 2
? Gear Correction
? Post Start
? Air Temp Duty Correction
? Post Start

? Data Logging: 448Kb of onboard data logging, Storage for approx 40 minutes at 10 logs per seconds,
6 channels of data
? Max 20 channels logging capability
? Tune can be password protected in software
? Rugged anodized aluminum casing

Power Requirements:
Source: 8.6 to 16.5 Volts DC
Consumption: 530mA @ 12Volts DC

Physical Dimensions:
ECU Dimensions Length: 154mm (174mm with MAP nipple)
Width: 158mm Height: 42mm Weight: 680g (1.5 lb)

Nissan 300ZX (Z32)
Engine Codes:


Manual only (Automatic not supported)

The Kit includes:
Pro Plug-in ECU, USB Cable, Programming Software CD, Quick Start Guide, Instruction Manual (on CD)

Please contact us for international shipping.